Concrete Driveways

Concrete driveways
that survive the winter.

Reinforced 32 MPa slabs on 150mm of compacted base, poured to exceed Alberta code rather than just meet it.

Licensed & insured
5-year warranty
Same-day quotes
0+
Projects complete
0+
Years in Calgary
0.0
Google rating
0yr
Workmanship warranty
What you get

Built to the spec that survives a Calgary winter.

Every job includes the same structural spec, the same reinforcement, and the same permit process.

Engineered for freeze-thaw
32 MPa concrete with 6% air entrainment resists Calgary’s repeated freeze-thaw cycles. A lower-spec pour starts spalling within three winters.
Proper base, not poured on dirt
150mm of compacted granular base before any concrete touches the ground. Skipping this is why slabs heave and crack.
Permitted and insured
Building permit pulled where required. Fully insured, WCB covered. No cash-only shortcuts.
How it works

From site visit to finished slab.

1
Site visit and quote
Jeff visits in person, measures, reviews grade and drainage. Same-day written quote.
2
Permit and base prep
Permit pulled where required. Excavation, grading, compacted granular base installed.
3
Form, reinforce, pour
Formwork set, rebar placed, 32 MPa mix poured in one continuous session.
4
Strip, seal, cure
Forms pulled at 24 hours. Curing compound applied. Full traffic after seven days.
Common questions

Concrete Driveways questions, answered.

Most residential driveways land between $9 and $14 per square foot depending on size, access, tear-out of the existing slab, and finish. A typical two-car driveway runs $6,500 to $11,000. Jeff gives you a fixed written quote after a site visit – no allowances that creep up later.

Two to three days on site for a standard residential driveway: one day for tear-out and base prep, one day to form and pour, and a short day to strip forms and seal. Weather can add a day.

Foot traffic after 24 to 48 hours. Light vehicle traffic at seven days. Heavy vehicles, trailers, or dumpsters should wait the full 28-day cure.

If you are changing the curb crossing or the driveway footprint, yes. Replacing an existing driveway in the same footprint usually does not require one. We handle the application either way.

MPa is compressive strength. Alberta code minimum for residential slabs is 25 MPa. We pour 32 MPa with 6% air entrainment as standard – the higher strength and the entrained air are what stop surface spalling after repeated freeze-thaw cycles.

Get started

Ready to build something that lasts?

Free quotes. No pressure. Jeff answers his own phone – you’ll hear back the same day.

Serving Calgary, Airdrie, Cochrane, Okotoks, Chestermere, Strathmore & High River
Call Jeff Free Quote